Replacement Battery for 1.86 Mile (3km) Solar Electric Fence Charger

• Charge the unit using a mains power adaptor or battery charger with 8.4V/1A output for at least 8 hours.

• Then place the energiser in direct sunlight for 3 days to fully recharge its internal battery.

• Ensure the charger is suitable for solar energiser batteries.

• Standard pulse rate: Every 1.5 seconds

• If the battery is discharging, the rate slows to one pulse every 3 seconds

No, this is normal. The sound comes from the transformer, which boosts the voltage from the battery. It does not indicate a fault.

Yes, it includes a safety fuse to protect the internal circuitry.

The unit works effectively in a temperature range of –20°C to +65°C (–4°F to 149°F), suitable for most climates.

No. The energiser does not need to be switched on during charging. Charging works in both the off and standby states.

If using a charger with an indicator light, the LED will turn green once the battery is fully charged.

• The ground rod should have at least 2.4 metres (8 feet) of contact with the earth.

• Space multiple rods at 3 metres (10 feet) apart if using more than one.

• Avoid placing near telephone lines or underground utilities.

• Black clip (negative): Connects to the ground rod

• Red clip (positive): Connects to the fence wire

No. Barbed wire is not recommended due to the risk of animals getting caught and receiving prolonged shocks. Use polytape, polywire, or polyrope instead, and position it 30 cm (12 inches) from any barbed wire.

• Aluminium wire: Excellent conductivity and long-lasting, but may sag over long distances and is more expensive.

• Polywire: More flexible, easier to handle, and suitable for most general-use applications.

Yes, the energiser works with electric poultry netting. Ensure your energiser’s output matches the netting’s requirements.

Yes. Direct sunlight is required for solar charging, even when the unit is turned off. Avoid shaded areas or indoor charging unless using a mains adaptor.

No. The system functions by completing the circuit through the animal and ground rods when contact is made with the live wire.

This may indicate over-voltage protection has activated due to high solar input. Check your unit’s specifications or contact support for troubleshooting.

Yes, but you must use insulators to attach polytape securely and prevent current leakage into the metal fencing.

Check the following:

• Poor grounding – Ensure the rod is installed at least 2.4 m deep

• Vegetation – Clear weeds or long grass touching the live wire

• Loose connections – Ensure all clips and terminals are secure and clean

Yes, but it must be well-insulated. Use a poly pipe for mechanical protection, but note it does not prevent electrical leakage without proper insulation on the wire.

1. Disconnect all fence wires and test voltage directly at the energiser using a fence voltage tester.

2. A consistent clicking sound and high reading indicate the energiser is functioning.

3. If the voltage is low even at the source, the energiser may need servicing

Yes. A closed loop is not required. The system completes its circuit through the grounding system when an animal makes contact with the live wire.